Get a Wiring Harness Quote

Direct wholesale pricing, fast response.
OEM Electrical Parts

The Best Way to Buy Used Lamp Wiring Harnesses Online

Experiencing flickering lights, melted connectors, or a short circuit? We offer fully tested, un-cut OEM lamp wiring harnesses for headlights, taillights, and fog lights. Fast shipping across New Jersey and nationwide.

Continuity Tested

All wires and connectors are verified for proper voltage flow and no shorts.

Plug-and-Play

No spliced wires. True factory connectors for a simple, safe installation.

OEM used lamp wiring harness with clean connectors and un-cut wires

Quality Used Lamp Wiring Harnesses You Can Trust

A damaged lamp wiring harness can cause dim headlights, flickering taillights, or complete lighting failure. Splicing broken wires or trying to repair a melted connector is often a temporary and unsafe fix. At Falcon Car Parts, we provide genuine used lighting harnesses that offer a secure, factory-spec connection.

Every used electrical harness in our inventory is carefully extracted by professionals to ensure no clips or sockets are broken during removal. We meticulously inspect for melted plastic, exposed copper, and corrosion inside the terminal pins.

  • Terminal Inspection: Checking internal pins for green corrosion or electrical burning.
  • Un-Cut Guarantee: We reject parts with chopped wires or aftermarket splicing.
  • Socket Integrity: Ensuring bulb sockets lock securely and weather seals keep moisture out.

Fast Delivery for Used Wiring Harnesses in NJ

Located in Clifton, NJ, Falcon Car Parts is perfectly positioned to provide rapid shipping for used lighting wiring harnesses in New Jersey. Electrical problems keep cars off the road, so we prioritize getting your replacement wires delivered safely and quickly.

From Jersey City to Newark and beyond, we are the Tri-State area's trusted source for reliable, road-tested OEM electrical components.

Careful Packaging

Packed securely to prevent crushing delicate plastic connectors!

Harnesses for Every Lighting Need

We source the exact factory wiring configurations for all sections of your vehicle's exterior lighting.

Headlight Harnesses

Main front wiring for high/low beams, whether your car uses standard halogen, HID, or advanced LED systems.

Taillight Harnesses

Rear quarter panel and trunk lid wiring that connects your brake lights, reverse lights, and turn signals.

Fog & Accessory Wiring

Lower bumper wiring sub-harnesses for fog lamps, side markers, and daytime running lights (DRLs).

Our 6-Point Quality Check for Lamp Harnesses

Electrical fires and short circuits are serious safety hazards. Every used wiring harness sold by Falcon Car Parts passes these checks:

  • 1. Connector Pin Review: We inspect every plastic plug for melted or blackened pins caused by overheating.
  • 2. Wire Sheathing Check: Ensuring the protective plastic loom or electrical tape is intact to prevent wires from grounding out.
  • 3. Locking Tab Verification: Confirming that the plastic retaining clips are unbroken so the harness won't vibrate loose.
  • 4. Bulb Socket Integrity: We verify that the actual bulb sockets hold lamps tightly without loose contacts.
  • 5. Water Seal Inspection: Checking the rubber weather seals on all exterior plugs to ensure they block rain and moisture.
  • 6. Exact VIN Match: Harnesses vary wildly by trim level; we guarantee the plug count and type match your specific car.

Common Questions About Buying Used Lamp Wiring Harnesses

Used lamp wiring harnesses typically cost between $35 and $150. The price depends heavily on the vehicle make and whether the harness is for standard halogen bulbs or complex factory LED/HID systems.

Yes. We thoroughly inspect our OEM harnesses to ensure there are no exposed wires, melted connectors, or internal breaks, making them a safe, plug-and-play replacement.

If the flickering is caused by a melted connector, a corroded ground wire, or a loose socket within the harness, replacing the harness will resolve the issue.

No. We only sell un-cut, genuine OEM harnesses. They are designed to plug directly into your vehicle's main body wiring harness and the respective light housings.

Lighting harnesses vary significantly based on vehicle trim (e.g., fog lights vs. no fog lights). We use your vehicle's VIN to guarantee we supply the exact plug configuration your car originally came with.

Generally, our harnesses are sold as the wiring, sockets, and connectors only. Light bulbs, fuses, and relays are typically not included unless specifically requested in your quote.

Melted connectors are usually caused by a poor electrical connection causing arcing (heat buildup) or the installation of high-wattage aftermarket bulbs that exceed the factory wire rating.

No. Front and rear wiring harnesses have completely different lengths, pin configurations, and bulb socket types. They are not interchangeable.

We reject harnesses with broken plastic locking tabs. A secure clip is essential to keep the connection tight and prevent moisture from entering the electrical system.

Since we operate out of Clifton, NJ, we provide extremely fast 1-2 day delivery for local customers, ensuring your vehicle isn't sidelined by electrical issues.